3D Kutz Barber Shop
Albuquerque, NM
3D Kutz Barber Shop
Professional barbering in Albuquerque.
3D Kutz Barber Shop is a barbershop at 1331 Juan Tabo Blvd NE in Albuquerque, New Mexico. It is listed in the Your Barber Connect directory of professional barber shops.
Shop Board
- Address
- 1331 Juan Tabo Blvd NE
Albuquerque, NM 87112 - Phone
- (505) 293-4356
- Find them
-
Get directions
Their website
Facebook
Instagram
Not published yet. Are you 3D Kutz Barber Shop? Send us your hours and we will add them.
Shop the setup
A working barber kit
Clipper, outliner and finisher - the three-piece Your Barber Connect would put behind a chair in a shop like this.
Supreme DarkStar 82 Metal Clipper STC82 – 9000+ RPM
$179.99
Babyliss FXONE LO-PROFX HIGH - PERFORMANCE TRIMMER # FX729
$164.99
Supreme Trimmer Darkstar™ Foil Shaver – 8500RPM Vector
$129.99
This kit is Your Barber Connect recommendation for a shop of this kind - it is not a list of the tools 3D Kutz Barber Shop actually runs. Nobody at the shop has confirmed their setup. If you are from 3D Kutz Barber Shop, tell us what you really use and we will put it here instead.
For shop owners
Stock your shop
The things that run out. Ships anywhere in the US.
Questions
Before you go
Where is 3D Kutz Barber Shop?
3D Kutz Barber Shop is at 1331 Juan Tabo Blvd NE in Albuquerque, New Mexico 87112.
What is the phone number for 3D Kutz Barber Shop?
You can reach 3D Kutz Barber Shop at (505) 293-4356.
Are these the exact tools 3D Kutz Barber Shop uses?
No. The kit shown is Your Barber Connect recommendation for a shop of this kind. The shop actual setup has not been confirmed.
Can I buy professional barber tools from Your Barber Connect?
Yes. Your Barber Connect has supplied professional barbers since 2012 with clippers, trimmers, shavers, blades, guards and back-bar supplies, and ships across the US.
Is this your shop?
Send us your photos, your hours, your booking link and the tools your barbers actually run. We will update this page and swap the recommended kit for your real one.
Update this page